Wright Storm Door Closer Installation Instructions

When we open the door and let go it flies shut but then doesn t close all of the way to adjust a pneumatic door closer either move the bracket that attaches the closer to the door or turn the screw on the end of the closer.

Wright storm door closer installation instructions. B step 3 attach door bracket to closer tube front hole with long connecting pin. This step by step instructional guide shows an ideal security closer but the steps a. This one will not work. Eye protection must be used during the installation to prevent injury from flying particles.

To see all the storm and screen door patio door and commerical closer products that are offered by wright products download our pdf catalog. Do not operate the storm door without closer s installed and adjusted to prevent door slamming. Always install on interior side of storm door. Instructions for installing or replacing storm and screen door closers.

Install on edge with hinges. If door frame is steel instead of wood a commercial door closer is required. Apply a spray sealant to the latch to protect it from long term weather damage then allow the latch to dry for four hours. Do not modify or alter the installation and specified use of the door.

Do not drill through door. Use wright storm and screen door latches with the included screws for optimal results though higher quality galvanized screws may be used instead of the included screws to protect the latch from weather damage. Screen door closers are typically installed on bottom but can be installed on top if desired although wind chain could be in the way. Read the complete installation instructions before proceeding with.

Wanda asks we recently installed a storm door. To see more of our product videos click here to visit the official wright products youtube channel. Most storm door units can be adjusted slightly to fit into a door frame. The next time you readjust the screens and glass storm panels in your self storing combo storm door don t forget to change the location of the long pin connecting the door bracket with the door closer tube photo when the glass storm panels are down place the connecting pin in the front hole of the closer tube closest to the door bracket.

This increases the closing pressure on the door. If your opening is too big for a standard door you can install a z bar extender a device that fills in the extra space between the door and frame. Do not change until installation is completed see fig. Read more for details.

The parameters for this adjustment vary by manufacturer.